Technical Specifications of the AVR
- Range of stabilization: +/- 20%
- Output range: less than +/- 1%, which means greater accuracy than 99%.
- Stabilization coefficient : 20 (Ratio between the input and the output stabilization range)
- Response time: 1 cycle
- Frequency accepted: 50 or 60Hz + / -5% (other on request)
- Harmonic Distortion: Do not introduce
- Yield: 98%
- Power Factor: 0.98
- Sensing: TRUE-RMS independent of frequency and temperature variation
- Adjustment system: indirect induction through a "buck-booster" transformer
- Signaling events: display and sound messages.
- Protection of under-voltage, over-voltage, over-load and current and phase failure
- Thermomagnetic circuit-breaker protection on input
- Electromagnetic contactor to drive the load and for protection even when in By-Pass mode
- By-Pass automatic and independent for each phase uninterrupted power with programmable limits and keeping active protection of the charge.
- Manual By-Pass independently for each phase and total to all phases
- Control panel with display of more than 50 parameters
- Viewing messages and events
- Liquid crystal display with 4 lines where you can find a Voltmeter, an Ammeter, the Frequency of all three phases, the messages of events and all the data from the device.
- Soft start: starts and after subtracting the voltage will rise slowly to the rated voltage.
- Automatic reset and programmable delay and number of times
- Manual reset via pushbutton or keyboard.
- Transformer with electrostatic shield (optional)
- Alpha-numeric keypad with 16 keys, each key lets you select for viewing 04 simultaneous parameters, also serves to set the desired variable parameter
photos: (click to enlarge it)
|
pass the mouse over the photo to see its description.
|
; "Standard AVRs models from 10 up to 150kVA")
; "Internal view of the standart mounted models")
; "Stock of new AVRs")
; "Internal view of à 3 phases 150kVA AVR")
; "Internal view of a 3 phases 50kVA AVR")
; "Internal view of a 1 phase AVR")
; "Front view of a 3 phases 150kVA")
; "Left side view of a 3 phases 150kVA AVR")
; "Right side view of a 3 phases 150kVA AVR")
; "Up view of a 3 phases 150kVA AVR")
'); "Standard AVR for 3Ø from 75 up to 150kVA (127cm X 43cm X 68cm)")
'); "Standard AVR for 3Ø from 10 up to 60kVA (74cm X 43cm X 768cm)")
'); "Standard AVR for 1Ø from 5 up to 15kVA (58cm X 31cm X 41cm)")
; "Back view of 1 phase AVR from 3 up to 15kVA")
; "Frontal view of the control and command panel")
; "3 phases Isolation Transformer")
; "Suply Module")
; "Sensoring module - isolated transformers")
; "Internal view of the power module with tiristors - SCR Power Block for AVRs from 75 up to 300kVA")
; "Control and power module with tiristors - SCR Power Block for AVRs from 75 up to 300kVA")
; "Control and power module with tiristors - SCR for AVRs from 3 up to 60kVA")
; "Interface module, by-pass and manual protection")
; "Exemple of a client installed AVRs")
'); "AVR for more then 250kVA (160cm X 80cm X 80cm)")
'); "AVR for more then 250kVA (160cm X 80cm X 80cm)")
; "Model Z18 - from 1 up to 5kVA 1Ø")
; "Model Z18 - from 1 up to 5kVA 1Ø")
; "Model Z18 - from 7,5 up to 10kVA 1Ø")
; "Model Z18 - from 5 up to 15kVA 3Ø")